top of page
Instructions: Blog2

Gripper Assembly Instruction

  • Writer: Noodle Team
    Noodle Team
  • Feb 12, 2020
  • 1 min read

Start by cleaning out any infill from parts. Parts should look like the images below (parts not too scale).

ree

Carefully push the peg of the bottom base into the smaller slot on the finger.

ree

Repeat this for all three fingers.

ree

Carefully push the pegs of the top base into the larger slots of the fingers.

ree

Tie a 12” piece of fishing wire to the slot in the shaft on the top base, circled below.

ree

Squeeze the gripper’s spring in between the bottom and top base and onto the shaft on the top base. Hot glue the top and bottom of the spring into place.

ree

Comments


©2019 by DIY Continuum Robot. Proudly created with Wix.com

bottom of page